Menu 0

TrackArmour Application Guide for Car Paint Protection Film

Quick Application Tips

  • Apply to clean and dry surface (waxed if possible)
  • Start from about the first 2 inches of the hood (between headlights) down to the bottom of the front bumper
  • Stick a small portion of the film to one side of the fender. As the film “falls/rolls” over the surface to the opposite direction, simultaneously run the felt tipped side of the applicator pad over the film to minimize bubbles. Repeat as you go down the front of the car overlapping the bottom edge
  • Use a razor blade to cut access film or for fine fitment around tricky areas

Application Techniques

Key Locations to Protect

Quick Removal Tips

  • Start removing the film from one side to the other. Because you overlapped the bottom edge of the film upon application, you can remove multiple layers with ease if you start from the bottom
  • Remove film slowly and as close to a 180 degree angle as possible. Avoid pulling the film up in a 90 degree angle

Disclaimer: TrackArmour is intended to help prevent paint damage but cannot guarantee 100% protection in any and all circumstances. TrackArmour itself cannot guarantee zero damage to your paint or surface due to the infinite amount of surface qualities this product can be placed on. We cannot be held liable for any damage and you are to use this product at your own risk.

Motorcade Car Rally 2026